Rubber Coated Magnets
Set of 4 replacement rubber coated magnets with female threads allowing for M5 screws (for gen 2 mounts) or M6 screws (for gen 3 mounts) to easily tighten in place. Stainless steel hardware included.
Magnet dimensions: 2.36" Diameter x 0.33” High
Holding Force: 60 lbs (each)
NOTE: If you have a curved roof, the mount itself has slight flex but you may need to use our pivoting leg adapters for maximum surface area contact when using rubber coated magnets, VHB landing pads, or suction cups. Please add to your order if required.
See installation instructions below.
Set of 4 replacement rubber coated magnets with female threads allowing for M5 screws (for gen 2 mounts) or M6 screws (for gen 3 mounts) to easily tighten in place. Stainless steel hardware included.
Magnet dimensions: 2.36" Diameter x 0.33” High
Holding Force: 60 lbs (each)
NOTE: If you have a curved roof, the mount itself has slight flex but you may need to use our pivoting leg adapters for maximum surface area contact when using rubber coated magnets, VHB landing pads, or suction cups. Please add to your order if required.
See installation instructions below.
Set of 4 replacement rubber coated magnets with female threads allowing for M5 screws (for gen 2 mounts) or M6 screws (for gen 3 mounts) to easily tighten in place. Stainless steel hardware included.
Magnet dimensions: 2.36" Diameter x 0.33” High
Holding Force: 60 lbs (each)
NOTE: If you have a curved roof, the mount itself has slight flex but you may need to use our pivoting leg adapters for maximum surface area contact when using rubber coated magnets, VHB landing pads, or suction cups. Please add to your order if required.
See installation instructions below.
-
Magnetic Feet:
1. Feed bolts (blue loctite already applied) through spaces at each of the 4 feet on the TRIO Flatmount
2. Thread the screws into the magnets and tighten using the hex key supplied.
3. Slide the Starlink dish onto the TRIO Flatmount until it clicks firmly into place and make sure it is secure
4. Ensure your magnetic surface and the mounting magnets are clean and free of debris
5. Place TRIO Flatmount onto magnetic surface and make sure there is good contact. THE TRIO FLATMOUNT LOGO (AND DISH CORD) SHOULD BE POINTED TOWARDS THE BACK (TRAILING EDGE) OF YOUR VEHICLE/BOAT ETC.
6. Enjoy your internet!
**When removing from the vehicle, lift from the rear portion of the mount itself rather than using the dish as a lever.
Check hardware regularly to make sure the magnets are secured to plastic enclosure
IMPORTANT NOTE: Many factors beyond TRIO Flatmount’s control and uniquely within user’s knowledge and control can affect the use and performance of a mounting product in a particular application. Given the variety of factors that can affect the use and performance of a TRIO Flatmount product, user is solely responsible for evaluating the product and determining whether it is fit for a particular purpose and suitable for user’s method of application.
